water heater booster pump

Water heater booster pump also known as hot water centrifugal pump, is the abbreviation of single-stage single-suction hot water centrifugal pump, including pump body, pump cover, motor with output shaft, pump shaft, bearing seat, impeller, mechanical seal and mechanical seal gland installed in the pump body, which is characterized in that it also includes the wafer coupling set between the output shaft and pump shaft of the electric motor, and the guide bearing installed on the bearing seat to support the pump shaft; The wafer coupling is rigidly connected with the motor output shaft and the pump shaft respectively, and a space distance is reserved between the motor output shaft and the pump shaft to facilitate the installation and removal of the mechanical seal and the mechanical seal gland. When repairing or replacing the mechanical seal, it is unnecessary to remove the motor and pump cover.

Water heaters are classified according to different principles of hot water production. There are four mainstream water heaters: electric water heaters, gas water heaters, air energy water heaters and solar water heaters. These four types of water heaters are very popular with users, but for some countries and regions with low water pressure, most users have such troubles, especially for users living in high-rise buildings, this aspect is particularly affected, such as going home from get off work at night Take a comfortable bath, but due to the low water pressure, the water output from the water heater is very small, which particularly affects the bathing experience. In response to this pain point, water heater manufacturers have introduced solutions with built-in water heater booster pumps to solve the problem of using water heaters in areas with low water pressure.

A good water heater not only has to meet all the needs of customers, but also has to face thousands of times of use of the switch, and the pressure of water in different regions. In response to these pain points of water heater manufacturers, Shenpeng has developed a water heater booster pump that has strong pressure, and has been used for a long time. It has been praised by the water heater industry and has cooperated with many well-known international manufacturers.

Dongguan Shenpeng Electronics Co., Ltd., started in 2004, is a professional manufacturer of a full range of miniature DC brushless pumps. It is an early domestic manufacturer of independent research and development, production, and core technology. Shenpeng Electronics has a strong factory area of nearly 2 10,000 square meters, the company has its own injection workshop and mold room, and 8 automatic production lines, with a daily output of more than 10,000 pumps. The company mainly supplies batches to manufacturers, and can customize production according to parameters to meet the personalized production of different manufacturers. As a well-known manufacturer of micro water pumps at home and abroad, Shenpeng looks forward to co-development with more manufacturers and explore cutting-edge technologies in the industry.

How to install the water heater booster pump?

1. First, wrap the water outlet of the booster pump with adhesive tape.

2. Install the automatic water flow switch on the water outlet of the booster pump.

3. Tighten the fixing screws.

4. Wrap adhesive tape around the water inlet of booster pump.

5. Connect the water inlet of booster pump with the water inlet pipe.

6. Connect the automatic water flow switch to the hose.

7. The booster pump outlet will be connected to the water heater.

8. Connect the booster pump inlet with the cold water pipe and then install it.

best water heater booster,electric water heater booster,water heater booster vs mixing valve,rheem water heater booster,tankless water heater booster pump,water heater booster valve